Teac US-100 - Manual (Page 6)

6
T ASCAM US-100
Additional information is introduced as needed in the •
following categories.
TIP
This is a useful hint about ways to use the unit.
NOTE
A note provides additional explanations for special situations.
CAUTION
These instructions should be followed to avoid injury, damage
to equipment or loss of data.
Trademarks
TASCAM is a registered trademark of TEAC Corporation. •
Microsoft, Windows, and Windows Vista are either registered •
trademarks or trademarks of Microsoft Corporation in the
United States and/or other countries.
Apple, Macintosh, Mac OS and Mac OS X are trademarks of
•
Apple Inc., registered in the U.S. and other countries.
Other company names, product names and logos in this
•
document are the trademarks or registered trademarks of their
respective owners.
Precautions for placement
The environmental temperature operation range of this unit is •
5–35° C (41–95° F).
Do not place anything on top of unit because it generates
•
much heat.
Do not put this unit on top of a power amplifier or other
•
equipment that generates heat.
Beware of condensation
Condensation could occur if the unit is moved from a cold place
to a warm place or used after a sudden temperature change, such
as after a cold room has been heated. If this occurs, let the unit
sit for one or two hours at the new room temperature before
turning the power on.
Cleaning the unit
To clean the unit, wipe it gently with a soft dry cloth. Do not use
benzene, paint thinner, ethyl alcohol or other chemical agents to
clean the unit as they could damage the surface or cause fading.
1 – Introduction