Teac US-100 - Manual (Page 17)

TASCAM US-100
17
2 Click the “Audio Devices” tab.
Set “Default Input,” “Properties for,” “Default Output”
and “System Output” to “USB Audio CODEC.” For the
“Format” in the “Audio Input” section, set the sampling
frequency and number of channels so that they match
that used in your audio application.
3 Use the INPUT knob on the front panel of the unit
to adjust the input level. Adjust the level so that the
overload (
OL ) indicator does not light
Overload indicator
4 To adjust the output level use the knobs on the front
panel, as well as the settings in Audio MIDI Setup. Use
the BALANCE knob to adjust the monitoring balance
between the input and computer sounds, and use the
OUTPUT knob to adjust the level output from the
OUTPUT and PHONES jacks.
Set the level to the maximum with the “volume” control.
Do not check the “Mute”. Then, close the window.
4 – Application Guide