Teac MX-2424 Tutorial - Manual (Page 32)

- 32 -
Setting One Button Recording
1) Press [SETUP], press [2] on the numeric keypad, and use the [Up Arrow] button to
scroll to the following display:
202 Record Key
* Record + Play
2) Press [TRIM].
3) Press the [Up Arrow] once to change to the "Record" setting.
202 Record Key
Record
4) Press [STORE/YES] to enable the new setting. You will be prompted for
confirmation. An asterisk will appear next to the new setting.
5) To change one touch "Record" back to "Record + Play," repeat steps 1 to 4.
Footswitch Punching
1) Make sure your MX-2424 is turned off, and plug in the footswitch. The footswitch jack
is located on the rear of your MX-2424 (at the bottom left corner).
2) Turn on your MX-2424, it will automatically sense the polarity of the footswitch.
3) Load a project, record enable a track, and press [Play].
4) Depress the footswitch to enter record.
5) Depress the footswitch again to exit record.