Teac DR-680 - Manual (Page 21)

TASCAM DR-680
21
Turning the power on and putting
the unit into standby
Turning the power on
When the power is in standby, press and hold the
STANDBY/ON key until the startup screen with
TASCAM DR-680
appears. The unit starts up and the
Home Screen opens.
CAUTION
Do not remove or insert an SD card until the Home
Screen appears.
Putting the unit into standby
When the power is ON, press and hold the STANDBY/
ON key until the following shutdown screen appears.
After the unit completes shutting down, the unit’s
power is set to standby.
CAUTION
Always use the STANDBY/ON key to put the unit power
into standby. When the power is ON, if you remove the
batteries or disconnect the power cord when using the
PS-1225L AC adaptor, all recording data and settings, for
example, are lost and such data cannot be recovered.
Inserting and removing SD cards
This unit can use SD cards with capacities of 2 GB or
more that are compliant with the standards for Class 4
(or faster) SD/SDHC cards.
A list of SD/SDHC cards that have been verified
for use with this unit can be found on the TASCAM
website (http://www.tascam.com/).
Inserting an SD card
1 Open the SD card slot cover on the right side
panel of the unit.
2 Insert the SD card in the direction shown in the
illustration until it clicks into place.
CAUTION
Do not remove an SD card while it is in use (being read).
Ejecting an SD card
1 Open the SD card slot cover.
2 Push the SD card gently, and it will come out of
the unit slightly and can be pulled out.
CAUTION
When connected with a computer by USB do not remove
the SD card from the unit.
3 – Preparations