beautypg.com

Automation, Touch function, Undo (static) – Teac DM-24 Addendum User Manual

Page 22: Touch function undo (static)

background image

22

TASCAM DM-24 2.0 release notes

DM-24 version 2.0—Release notes—Automation

Automation

Touch function

The touch function is used to overwrite and erase
POD, rotary encoder or switch moves. Since these
controls are not touch-sensitive, this is a useful way
to erase previous mix moves on these controls.

The relationship between the previous mix moves
and moves made using the touch function is shown
below

To operate the touch function:

1

Enable Global Write mode.

2

Press and hold the

TOUCH

key and while

holding it, operate the non touch-sensitive
control (PODs, rotary encoders or switches)
to begin writing or overwriting at the con-
trol’s current value. While moving the con-

trol, you can release the

TOUCH

key. Write

mode is still enabled for this control.

3

Make a new mix move or end writing manu-
ally by pressing the

REVERT

key.

If a new move is written, the revert action
follows the settings made on the

AUTO MAIN

screen.

UNDO (static)

The

UNDO

key now can be used to undo adjustments

made to a static control during a mix pass, as well as
its previous “undo all mix moves” function.

8 sec

8 sec

+12

+6

+3

0

-3

-6

-12

+12

+6

+3

0

-3

-6

-12

1 sec

2 sec

3 sec

4 sec

5 sec

6 sec

7 sec

1 sec

2 sec

3 sec

4 sec

5 sec

6 sec

7 sec

-9

Existing Move

Mix Move

Press/Hold

TOUCH

&

Move control

New Move

Auto or Manual

Revert

Control

Writing

Revert

Time