Teac DM-24 Addendum - Manual (Page 20)

20
TASCAM DM-24 2.0 release notes
DM-24 version 2.0—Release notes—GPI functionality
On the MIDI/MC SETUP page, the filtering of MIDI
Control Change messages can now be carried out
independently for external control (
EXT.CTRL
) and
Mix parameters (
Mix Parm
). These can be set inde-
pendently for In and Out for both types of Control
Change message.
HUI emulation
The DM-24 is now able to emulate the Mackie
HUI™ device, and can therefore act as a controller
(pans, sends, faders and mutes) for various DAW
applications (e.g. ProTools, Digital Performer and
Nuendo) via MIDI.
NOTE
This is not a 100% emulation of every one of the
Mackie HUI functions, and there is no guarantee,
despite our best efforts, that an external unit that is
controlled by a Mackie HUI will behave identically in
every circumstance as the same unit controlled by the
DM-24’s HUI emulation.
The HUI “device” is a closed loop MIDI device, and
is selected from the machine control list (if the closed
loop is not detected, the display shows a cross for the
device type, rather than the double-headed arrow
usually used to denote a closed loop device. There is
one parameter which may be set here—the MIDI
channel (from
1 through 16 ).
The setup enables MIDI to be received by the HUI
emulation as well as setting the ID of the device.
HUI transport emulation, etc. can be enabled or dis-
abled in this screen and the external control screen
(described below) enables other functions.
As with other machine control devices, the
SCREEN
button jumps to the special screen from which the
HUI is controlled: