Teac CD-P800NT-B - Manual (Page 48)

The submenus appear in the following order.
IP Address
View/set the IP address.
MAC Address
View this unit's MAC address.
DHCP
Enable (default setting)
DHCP is enabled.
Disable
DHCP is disabled.
Subnet Mask
View/set the subnet mask.
Gateway
View/set the default gateway.
DNS Server
View/set the DNS server address.
Proxy URL
Set the proxy server address.
Proxy Port
Set the proxy port number.
o This only appears when a proxy URL has been set.
Net Standby
This sets whether or not the unit can be controlled over a
network when the unit is in standby.
Disable (default setting)
When the unit is in standby, it cannot be controlled
over a network.
Enable
When the unit is in standby, it can be controlled over a
network.
o When set to “Enable”, more power will be consumed
when the unit is in standby.
Update
You can update the firmware of this unit. Do not put the
unit in standby during an update.
o See “Updating the firmware” on page 49 for update
procedures.
Version
This shows the current firmware version.
This unit has two types of firmware: Main and DSP.
Their versions are shown in the following format.
abcd-ef00-000
Main: a.bc
DSP: d.ef
Example
If “1001-0100-000” appears, the firmware versions are as
follows.
Main: 1.00
DSP: 1.01
CDP via USB?
You can update the firmware using a USB flash drive.
Settings (continued)
48