Teac CD-P800NT-B - Manual (Page 10)

Handling discs
o Always load discs with their labeled sides up.
o Be careful when handling discs. If the side that contains
the data (unlabeled side) is scratched, smudged with
fingerprints or otherwise dirty or marred, errors could
occur during playback.
o To remove a disc from its case, while pressing down on
the center of the case, hold the disc by its edges.
Removing discs Holding discs
Disc storage
o After you finish using a disc, always put it back into its
case for storage. Failure to do so could result in warping
and scratches.
o Do not leave discs in places that are exposed to direct
sunlight or that are very humid or hot. Doing so could
cause discs to become deformed or degraded, making
them unplayable.
o CD-R and CD-RW discs are more susceptible to the
impacts of heat and ultraviolet rays than ordinary CDs.
For this reason, do not leave them for long times in
places that are exposed to direct sunlight or near
devices that generate heat, for example.
o Always clean discs before storing them. Leaving a disc
in an unclean state might result in skipping or degraded
sound quality.
Notes about discs (continued)
Maintenance
o If the side of the disc that has the data encoded on it
(unlabeled side) becomes dirty with fingerprints or
dust, use a soft cloth to wipe the surface from the cen-
ter directly toward the edge.
o Never use record cleaners, antistatic treatments, thin-
ners or similar chemicals to clean discs. Such chemicals
could harm the surface of the disc.
10