Teac CD-P800NT-B - Manual (Page 15)

Names and functions of parts (main unit)
A
STANDBY/ON button
Press this button to turn the unit on or put it in standby
mode.
o When this unit is in standby mode, it consumes
standby power. For this reason, we use the term
“standby” rather than “off”.
B
PHONES jack
To listen with headphones, minimize the volume
before connecting them to the PHONES jack, and
then gradually raise the volume.
V Do not connect or disconnect headphones or
turn the unit on or put it in standby while wear-
ing them. Sudden loud noises could occur, which
might cause hearing damage.
C
LEVEL knob
Use to adjust the headphones volume.
Turn it clockwise to increase and counterclockwise to
decrease the volume.
D
Remote control signal receiver
When using the remote control, point it toward this
receiver.
E
SOURCE button
Use this button to select the source.
F
USB port
Use to connect an iPod, iPhone or USB flash drive to
the unit.
o When changing the input source, this port is iden-
tified as “USB(F)”.
o Do not connect computers or similar devices to
this unit’s USB ports. Audio from computers cannot
be input through this unit's USB ports.
G
Display
H
Disc tray
I
Tray open/close (-) button
Press to open and close the disc tray.
J
Stop (8) button
Press to stop playback.
K
Play/pause (7/9) button
When stopped or paused, press to start playback.
During playback, press to pause.
L
RETURN button
When a menu is open, press to return to the previous
menu.
M
MENU/ENTER (.//) dial
Turn clockwise to skip to later tracks or counterclock-
wise to skip to earlier tracks.
Press to use as the ENTER button to confirm settings.
Press and hold to use as the MENU button.
Turn to change the item or setting value shown when
a menu screen is open.
A B C D E F G H I J K L M
15
ENGLISH