Super Systems 9010 Series - Manual (Page 46)

SSi Manual Series 9010 – eSPP Programmer Page 46
Guarantee High Assignment
An opcode with a GH prefix stands for guarantee high. During a recipe, a guarantee high will allow the
recipe timer to run only while the PV is at or below the upper limit. The upper limit is the value of the set
point plus the wait limit.
If the PV moves above the upper limit, the recipe will pause and a new timer will begin. This timer is
called the Default Hold Time and can be found and adjusted in the Menu under Furnace Setup. This timer
will keep track of the amount of time the PV has been above the upper limit. If the PV fails to move below
the upper limit within the Default Hold Time, the programmer alarm will be activated. Once the PV
moves below the upper limit, the recipe timer will resume.
For example, if the PV is temperature with a 1500° set point and the wait limit is 15°, the recipe timer will
continue to run as long as the PV is at or below 1515°. If the PV moves above 1515°, the recipe timer will
pause and the Default Hold Time countdown will begin. The recipe timer will resume once the PV moves
back to 1515° or below.