Super Systems 9010 Series - Manual (Page 14)

SSi Manual Series 9010 – eSPP Programmer Page 14
Chapter 2 - OPERATION
Overview
 The Series 9010 eSPP Operator Interface is either a 3.5”, 5.7”, or 12.1” color, touch-screen
display.
 On power-up, the Series 9010 will display a logo screen for sixty seconds and then switch to
the default Status Screen.
 The active menu buttons on the status display are located at the bottom of the display.
Status Display
The Status display shows the
atmosphere and temperature controller
information as well as an overview of
the programmer. There are four active
buttons at the bottom of the Status
Display: Menu, Chart, Recipe, and
Loops.
Menu
There are three levels of menus in the Series
9010.
 The first level is the operator level . These
are functions or operations that are
typically handled by the furnace operator.
This menu is accessed without the need
for a pass code.
 The second level is the supervisor level .
This level requires the entry of a level 1 or
a level 2-pass code.
 The third level is the administrator level .
This requires the level 2-pass code ONLY.
As shipped, the supervisor and administrator
level codes are set as 1 and 2 respectively. The pass codes can be changed at the Passcode and Alarm
Screen.
Note: Any level can access a lower level screen. For instance, the Administrator level passcode
can access all of the Supervisor and Operator level screens .
The menu items are explained in detail in Chapter 3 – Configuration.