Sundance SMT941 - Manual (Page 23)

User Manual SMT941 Page 23 of 43 Last Edited: 23/08/2011 17:24:00
Setting Bit 11:10 Description Extended lock detect window - LOCKW
0 ‘00’
1 ‘01’
2 ‘10’
3 ‘11’
Setting Bit 13 Description DIVSYNC_DIS
0 ‘0’ Start signal is synchronised to N/M divider input clock
1 ‘1’
Setting Bit 14 Description START_BYPASS
0 ‘0’ Start signal is synchronised to VCXO clock
1 ‘1’ Start synch block is bypassed
Setting Bit 15 Description INDET_BP
0 ‘0’ Synch logic active when VCXO/AUX clocks are available
1 ‘1’ Synch logic is independent from VCXO/AUX
CLOCK Register 13 0x23.
Clock Register 13 0x23
Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
1 Reserved
Default ‘00000000’
0 Reserved BIAS_DIV_FB NPRESET
_MDIV LOW_FD_
FB_EN
PLL_LOCK_B
P
Default ‘000’ ‘00’ ‘0’ ‘0’ ‘0’
Reset Register 13 0x23
Setting Bit 0 Description PLL_LOCK_BP
0 ‘0’ Synch logic waits for the first PLL lock state
1 ‘1’ Synch logic independent from first PLL lock state
Setting Bit 1 Description LOW_FD_FB_EN
0 ‘0’ Synch logic is independent from VCXO/DIV_FB frequency
1 ‘1’ Synch logic is started for VCXO/DIV_FB > 600khz
Setting Bit 2 Description NPRESET_MDIV
0 ‘0’ M-divider uses nHOLD as NPRESET
1 ‘1’ M-divider not preset by nHOLD
Setting Bit 4:3 Description BIAS_DIV_FB
0 ‘00’ No current reduction
1 ‘01’ 20% current reduction
2 ‘10’ 30% current reduction
CLOCK Register 14 0x24.
Clock Register 14 0x24
Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
1 Reference Divider[11:4]