Sundance SMT911 - Manual (Page 21)

SMT911 User Manual SMT911 Last Edited: 01/06/2010 10:09:00
The SLB carries all LVTTL signals from the TIM base module to the devices on the
SMT911 mezzanine. The transceiver card is equipped with the 120-pin male
connector with the Samtec Part Number QSH-060-01-F-D-DP-A. The corresponding
female connector QTH-060-01-F-D-DP-A is located on the base module.
All signals routed by this connector are single-ended.
The pins are grouped in banks A, B, C, with the pin-out specified in the following
table. For further descriptions of the pins and their function, please consult the
datasheet.
Pin # Pin Name Signal Desc. Pin # Pin Name Signal Desc.
1 ADQ_A_U<11> Upper data pin 11 2 ADQ_A_U<10 Upper data pin 10
3 ADQ_A_U<9> Upper data pin 9 4 ADQ_A_U<8> Upper data pin 8
5 ADQ_A_U<7> Upper data pin 7 6 ADQ_A_U<6> Upper data pin 6
7 ADQ_A_U<5> Upper data pin 5 8 ADQ_A_U<4> Upper data pin 4
9 ADQ_A_U<3> Upper data pin 3 10 ADQ_A_U<2> Upper data pin 2
11 ADQ_A_U<1> Upper data pin 1 12 ADQ_A_U<0> Upper data pin 0
13 ADQ_A_L<11> Lower data pin 11 14 ADQ_A_L<10> Lower data pin 10
15 ADQ_A_L<9> Lower data pin 9 16 ADQ_A_L<8> Lower data pin 8
17 ADQ_A_L<7> Lower data pin 7 18 ADQ_A_L<6> Lower data pin 6
19 ADQ_A_L<5> Lower data pin 5 20 ADQ_A_L<4> Lower data pin 4
21 ADQ_A_L<3> Lower data pin 3 22 ADQ_A_L<2> Lower data pin 2
23 ADQ_A_L<1> Lower data pin 1 24 ADQ_A_L<0> Lower data pin 0
25 ADQ_A_SCLK Serial clock ADQ A 26 ADQ_A_SDI Serial DIN ADQ A
27 ADQ_A_CS Serial CS ADQ A 28 ADQ_A_LOPWR Low power ADQ A
29 ADQ_A_RXDWN RXDWN ADQ A 30 ADQ_A_TXDWN TXDWN ADQ A
31 ADQ_A_IFACE1 IFACE1 ADQ A 32 MAX_A_SER_CS Serial CS Maxim A
33 ADQ_A_IFACE3 Clock ADQ A 34 MAX_A_TX_ENA TX Enable Maxim A