Sundance SMT911 User Manual
Page 10
SMT911 User Manual SMT911
Page 10 of 38
Last Edited: 01/06/2010 10:09:00
• 4 SMA connectors (50 Ohm) for dual-band antennas providing TX/RX
• Two MMCX connectors (50 Ohm) external clock input
• Samtec BKT connector for 5 V and 3.3 V power supply
• 120-pin Samtec QSH connector for all digital I/O signals
• JTAG connector for debug/access to FPGA on base-board.
• Plugs directly into a wide range Sundance SLB TIMs
Each pin on the BKT power connector (33 pins in total) can carry 1.5 A. Digital 5V
(D+5V0), digital 3V3 (D+3V3) and digital ground (DGND) are provided over this
connector. D+3V3 and D+5V0 are assigned four pins each. The daughter card can
thus draw a total of 6A of each of these two supplies.
The major elements of the SMT911 are shown in the block diagram below (single
channel shown).
- SMT107 (16 pages)
- SMT6035 v.2.2 (39 pages)
- SMT6012 v.4.6 (22 pages)
- FC100 (12 pages)
- FC108 v.1.1 (10 pages)
- SMT6065 v.4.0 (45 pages)
- FFT v.2.1 (19 pages)
- SMT111 (18 pages)
- SMT118LT (10 pages)
- SMT118 (20 pages)
- SMT123-SHB (13 pages)
- SMT128 (15 pages)
- SMT145 (18 pages)
- SMT148 (35 pages)
- SMT130 v.1.0 (46 pages)
- SMT148FX (48 pages)
- SMT310Q (55 pages)
- PARS (70 pages)
- SMT166-FMC (52 pages)
- SMT166 (44 pages)
- SMT300Q v.1.6 (61 pages)
- SMT310 v.1.6 (50 pages)
- SMT317 (24 pages)
- SMT326v2 (24 pages)
- SMT338 (19 pages)
- SMT349 (32 pages)
- SMT339 v.1.3 (27 pages)
- SMT338-VP (22 pages)
- SMT358 (25 pages)
- SMT351T (37 pages)
- SMT351 (25 pages)
- SMT350 (45 pages)
- SMT362 (30 pages)
- SMT365G (23 pages)
- SMT364 (37 pages)
- SMT373 (15 pages)
- SMT368 (24 pages)
- SMT370v3 (46 pages)
- SMT377 (22 pages)
- SMT381 2007 (31 pages)
- SMT381-VP (81 pages)
- SMT387 (42 pages)
- SMT391 (18 pages)
- SMT384 (47 pages)
- SMT390-VP (55 pages)