Sundance SMT368 - Manual (Page 24)

8 Physical Properties
Dimensions 106.68mm x 63.5mm 4.2’’ x 2.5’’
Weight 50g.
Supply Voltages
Supply Current +12V
+5V
+3.3V
-5V
-12V
MTBF
Power consumption:
ZBT
2.7Watts
CPLD 0.2Watts
FPGA depending on the implemented design, the power consumption can reach a
maximum of 15Watts (approx.)
Sundance recommends you to analyse the FPGA power drawn by using
Xilinx XPOWER
before implementing your design in the FPGA. This will tell you if you need to use the
external power connector provided on our carrier boards.
9 Safety
This module presents no hazard to the user when in normal use.
10 EMC
This module is designed to operate from within an enclosed host system, which is build to
provide EMC shielding. Operation within the EU EMC guidelines is not guaranteed unless it
is installed within an adequate host system.
This module is protected from damage by fast voltage transients originating from outside the
host system which may be introduced through the output cables.
Short circuiting any output to ground does not cause the host PC system to lock up or reboot.
User Manual SMT368 Page 24 of 24 Last Edited: 31/12/2008 13:53:00