Studio Technologies 50 2000 - Manual (Page 38)

Issue 4, July 2000 Model 50/51 User Guide
Page 38 Studio Technologies, Inc.
Slate Tone
Type: 50Hz sine wave
Level: 10dB below slate communications audio
level (nominal)
Mic Module Connection
Designed for use with the Model 71 Mic Module.
The Model 71 provides the communications audio
source when MIDI messages are sent directly into
Model 50 Central Controller; i.e., the installations
where the Model 51 Control Console is not used.
Also can be used to connect alternate communica-
tions audio source with nominal signal level of
–10dBu.
LED Indicators
Qty: 7, power present, control console over cur-
rent, talent amp over current, input data present,
Model 50 input data present, input 7 +4dBu, dub
output +4dBu
Dimensions (Overall)
19.00 inches wide (48.3cm)
1.72 inches high (4.4cm)
8.75 inches deep (22.2cm)
(1 standard rack space)
Weight
8.9 pounds (4.1kg)
Model 51 Control Console
Mounting
Desktop. Provision for stand mounting provided.
Power Requirements
15Vdc filtered and regulated, 90mA maximum,
provided by Model 50 Central Controller
Connectors
To Model 50 Central Controller: 5-pin DIN-type,
female
Remote Control: ¼-inch, 3-conductor phone jack,
gold-plated contacts (Neutrik)
Internal Microphone
Type: electret condenser
Frequency Response: 3dB roll off at 105Hz
Remote Control Contacts
Connect normally open contacts to allow operation
of remote talk to studio, remote control room
source select, and remote talk to headphones
functions
Dimensions (Overall)
7.4 inches wide (18.8cm)
2.6 inches high (6.6cm)
7.3 inches deep (18.5cm)
Weight
2.5 pounds (1.1kg)
Model 35 Talent Amplifier
Mounting
Desktop. Provision for stand mounting available
as option.
Power Requirements
+20-32Vdc (modulated with left channel audio),
provided by Model 50 Central Controller
Power Present LED
Red LED indicates presence of operating power
Connectors
Input (from Model 50): 3-pin XLR-type, female
(Neutrik)
Loop Thru: 3-pin XLR-type, male, connected in
parallel with input connector (Neutrik)
Headphone Outputs: 2, ¼-inch, 3-conductor
(stereo) phone jacks, gold-plated contacts
(Neutrik)
Headphone Output
Qty: 1, feeds two headphone jacks
Load: intended for connection to one or two pairs
of headphones with total impedance of 75 ohms
or greater
Output Level: user adjustable
Maximum Output Voltage: 16V peak-to-peak into
150 ohms @ 1% THD+Noise, 400Hz
Distortion (THD+N): 0.03%
Frequency Response: 20Hz-20kHz ±0.5dB
Dimensions (Overall)
4.2 inches wide (10.7cm)
2.0 inches high (5.1cm)
5.3 inches deep (13.5cm)
Weight
0.8 pounds (0.4kg)