SoundTraxx Tsunami Installation - Manual (Page 7)

Tsunami Installation Guide Page 4 Tsunami Installation Guide Page 4
Pre-installation Check List
It will be a great temptation to begin connecting wires immediately. Before
you install your Tsunami Digital Sound Decoder, there are some simple
precautions you should take.
First, read the instruction sheet that came with your decoder carefully! It will
always be the source of the most recent information. Then finish reading this
Installation Guide.
• The DSD should be handled carefully in a static-free environment. To
discharge static electricity, touch a water pipe or grounded, metal surface
before handling the decoder.
• Never remove the decoder’s protective shrink tubing. First, you will void
your warranty and second, you will compromise the decoder’s built in
thermal management system.
• Never make connections to the decoder while it is powered. Doing so
makes for an accident waiting to happen.
• Make sure all electrical connections are insulated. Avoid using electrical
tape, as it tends to unravel over time. We recommend using heat
shrinkable tubing instead.
• Never allow the decoder leads to come in contact with any DCC track
wiring except those specifically designed for that purpose.
• Never allow speaker outputs to become shorted together.
• Never allow motor outputs to become shorted together.
• Do not exceed the output ratings for which the decoder is designed.
• Take your time and have fun!
In the event you damage your decoder during installation, our return policy
is stated in the rear of this manual as well as posted on our website with an
effective date reflecting any changes.
Tools and Materials You Will Need
In addition to the common hand tools found on most modeler’s workbenches,
you should have at your disposal:
• Low wattage (under 25 watts) solder iron
• Rosin Core Solder
• Hobby Knife
• High Speed Motor Tool (such as a Dremel)
• Miniature Screwdriver Set
• Diagonal Cutters
• Multi-meter
• Double Sided Tape
• Silicone RTV
• Heat gun
• Assorted sizes of heat-shrink tubing (SoundTraxx P.N. 810037)
• Insulative Tubing (SoundTraxx P.N. 810036)
Installation