Smithy GN1300 - Manual (Page 74)

The powerfeed operates in either the x- or y-axis. It incorporates the quick
change gear box by engaging the Selector Lever (1-7) and Selector Lever (I-III)
as well as the carriage gearing by engaging the powerfeed lever into the
proper position.
The two-position powerfeed function selector must
be in either the lathe or mill position according to
which machine function is being used at the time.
CAUTION
Figure 9.1 Always match the Powerfeed Function lever to
the appropriate operation
Figure 9.2 Selector Lever (1-7) & Selector Lever (I-III)
! NOTICE !
If the mill/lathe clutch is in the mill position, you
must also position the powerfeed function selector
in the mill position to enable the machine to move
the table.
9:Using Powerfeeding
9-2 Or Visit www.smithy.com