Smithy GN1300 - Manual (Page 12)

Machine Safety Rules
1. Stop the machine before servicing. Stop the machine before making changes,
removing debris, or measuring your work.
2. Don’t over reach. Don’t reach over the machine when it’s operating. Keep your hands
out of the way.
3. Turn the switch OFF. Turn the switch to off before plugging in the machine. Turn
the speed dial to zero before starting your machine.
4. Use proper tooling. Use only recommended accessories and understand how they
should be used before trying them out. Don’t try to make a tool into something it isn’t or
attempt to use a tool in inappropriate ways. Remember to always use the proper tooling
for the material you are cutting. Reference a general machining guide such as Machinist
Ready Reference for recommended tooling for your material.
5. Secure your work. Before starting your machine, be certain that your workpiece is
properly and securely mounted. Flying metal is dangerous!
6. Do not run you machine beyond its limits of travel. Before starting your
project, ensure that your work area does not go beyond the limits of travel on your
machine. Going beyond the limits of travel will cause serious damage to your machine
which will not be covered by your warranty.
7. Run your machine at recommended spindle speeds and feed rates. Always
cut at the recommended speed and feed rates for the type of metal that you are cutting
for optimum performance. Do not begin your cut until the machine has reached the full
and proper speed.
8. Do not change the direction of the spindle rotation or leadscrew rotation
while your machine is running. Changing the rotation direction of the spindle or
leadscrew while your machine is running could cause serious damage to your machine.
9. Do not stop the spindle by hand. Always use your on/off switch to stop the spin-
dle from rotating.
10. Do not clear chips by hand. Metal chips are very sharp and can easily cut your
hand. Use a brush to clear chips.
11. Protect bed ways. When removing or installing tooling from your lathe spindle,
place a piece of wood or other material across the bed to protect the ways from being
damaged if the tooling is dropped.
12. Keep your machine maintained. Always replace worn or damaged parts before
using your machine to prevent damage to your machine or the operator. Follow the
maintenance schedule outline in this manual for peak performance.
2: Safety
WARNING
2-3 Or Visit www.smithy.com