Sloan ESD-200 Installaton - Manual (Page 2)

Model ESD-20080/25085/30880/35187 Soap Dispenser and Faucet Combinations
When the ESD Soap Dispenser is packaged with a Sloan ETF-80, ETF-880,
EBF-85 or EBF-187 Faucet for installation on a 4” centerset sink, a special
Trim Plate (ETF-299-A) is supplied. For these models, the Faucet must
install on the left side and the Soap Dispenser on the right.
When installing the ESD-20080/25085/30880/35187, use these
instructions in conjunction with the Installation Instructions packaged with
the faucet.
5-3/8”
(137 mm)
1-
1/
2”
(3
8
m
m
)
4-1/4”
(108 mm)
1/32”
(1 mm)
15/16”
(24 mm)
BRASS
SHANK
ADJUST TO
COUNTER
HOLE 1”
(25 mm) 3-5/16”
(84 mm)
6-15/16”
(176 mm)
14-1/16”
(357 mm)
1-5/8”
(41 mm)
2-31/32”
(75 mm)
FLANGE
NUT
FLANGE
NUT
1/8”
(3 mm)
S
IN
K
COUNTER
FLANGE
NUT
4-1/4”
(108 mm)
1-13/16”
(46 mm)
SENSOR
SOAP DISPENSER ROUGH-IN
FAUCET SOAP
DISPENSER
HOT
WATER
SUPPLY
COLD
WATER
SUPPLY
ETF-299-A
2 PIECE
TRIM PLATE
INSTALLATION
The ESD-200/250/300/350 Soap
Dispenser oftentimes can be
mounted in the left or right hole of a
4” or 8” center-set sink. The ability to
do this is contingent upon the width
of the faucet spout and accessibility
to the unit on the underside of the
sink (the Motor and Soap Bottle
cannot interfere with the water or
drain lines). When such interference
above or below the sink occurs, the
Soap Dispenser must be installed
through the countertop to the side of
the sink as shown.
2
Faucet Model
ESD-25085 Shown