Skutch Electronics CK-1P - Manual (Page 3)

Page 3 of 5
5- Connect the short modular cord from [1&2 to Phone] on CK-1 to [LINE 1&2] on
Phone.
6- Connect the short modular cord from [3&4 to Phone] on CK-1 to [LINE 3&4] on
Phone.
7- The audio cord that comes with the CK-1P is ONLY used for CD Players. If you have
a digital player, then you should be using the audio cord that came with your digital unit.
Connect the proper audio cord from your music source, to the AUDIO IN jack on the
back of the CK-1 box.
8- Connect a MOD cord from Telephone Wall Jack 1&2 to [1&2 to Line] on CK-1.
9- Connect a MOD cord from Telephone Wall Jack 3&4 to [3&4 to Line] on CK-1.
10- Connect the POWER CUBE from the CK-1 box to 115VAC power.
KX-TG2000 Installation Notes:
The KX-TG2000 and KX-TG4000 are very similar. The following is a list of the
differences in the installation process between the two phones.
1- When you mount the "SENSOR BOARD" on the telephone, the "3" and "4" on the
SENSOR board will represent line 1 and 2 on the telephone.
2-Connect the short modular cord from [3&4 to Phone] on the CK-1 to [LINE 1&2] on
the Phone.
3- Connect a MOD cord from the Telephone Wall Jack 1&2 to [3&4 To Line] on the
CK-1.
Fig. 5
Connect to Wall Jack 1&2
Connect to Wall Jack 3&4
To Audio Source
Line 3&4 Line 1&2