Skutch Electronics CK-1P - Manual (Page 2)

Page 2 of 5
CAUTION: The SENSOR BOARD must be aligned correctly or the unit will not
operate properly. If you need to removing the SENSOR BOARD once attached, slowly
lift up on one edge of the SENSOR BOARD. Pulling the SENSOR BOARD off fast
could damage the foam pad.
3- Position the CK-1P box under the base telephone with the jacks facing towards the
back of the phone. (See Fig. 3).
4- Connect the SENSOR BOARD CABLE between the CK-1P Box and the SENSOR
BOARD as shown in Fig. 4.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Align to GRAY edge of DISPLAY on Phone
Downward Edge
Align with
Here!
Here!
Here!
Sensor Board Alignment