Skutch Electronics DL-4 - Manual (Page 4)

Page 4 of 7
Testing the Pre-recorded Announcement
From the IDLE MODE simply press the TEST button and the current announcement will
play back through the internal speaker. If you wish to abort the TEST simply HOLD
down the IDLE button until the unit stops playing.
ANSWER MODE
After you have recorded your announcement you are now ready to start answering calls.
To place the DL-4 in the answer mode, simply press the ANSWER button until the unit
BEEPS.
Answer Mode Display Information
Upper Left hand corner = MODE
Upper Right Hand Corner = Six Digit Call Counter (Must be in IDLE MODE to RESET)
Lower Left hand Corner = Shows the lines that are currently active
Lower Right Hand Corner = Shows the length of the pre-recorded announcement
Exiting ANSWER MODE
Simply press the IDLE button for 2 seconds.
Answering the Call
The DL-4 answers all line after the first ring. This can not be adjusted.
Disconnect Methods
The DL-4 has two disconnect methods.
CPC Disconnect
If the DL-4 detect a CPC or Battery Reversal during an inbound call, it will automatically
disconnect
Play Loop Disconnect
The DL-4 will automatically hang up after the announcement has played a preset number
of times. The default value is 3. The number of LOOPS can be adjusted from 1 to 6.
To adjust the number of loops do the following:
1- From IDLE MODE press and HOLD DOWN the COUNTER RESET Button until the
unit BEEPS (approximately 18 seconds). The display will read: Play Loops. Press the