Installation, Testing the system, Lights on ck-1 box – Skutch Electronics CK-1A5 User Manual
Page 4: 1&2 to line, Line 1 jack, Line 2 jack
Page 4 of 5
6- Connect the POWER CUBE from the CK-1 box to 115VAC power. That's it!
Installation
(Two Mod Cords)
If your phone is installed with two telephone cords, one for line 1 and another for line 2, then you will have
to use the enclosed adapter to convert the two separate cords to a single double line cord. Once this is done
you can follow the Installation (Single Mod Cord) instructions.
Testing the System:
1- Pickup line 1 on your telephone. The No."1" LED on the CK-1A5 Sensor Board
should light up. Hang up.
2- Repeat this test for line 2. If both lines light up when picked up, the CK-1A5 is
working properly. If either light does not light up, then
a) Make sure that the CK-1A5 and Telephone is connected to power.
b) Make sure that the SENSOR BOARD is aligned properly.
Lights on CK-1 Box.
When you place a line on HOLD, the corresponding LED on the rear of the CK-1A5 box
lights up to confirm the Promotion-On-Hold condition.
Connect to:
1&2 to LINE
On Ck1
Connect to:
Line 1 Jack
Connect to:
Line 2 Jack