Fig 3 – Skutch Electronics CK-1A5 User Manual
Page 3
Page 3 of 5
4- Connect a MOD cord from Telephone Wall Jack 1&2 to [1&2 Line on CK-1A5]
(Fig 2)
5- Locate the CK-1A5 "SENSOR BOARD", peel off the protector paper from the
bottom of the sensor board, and carefully place it OVER the LINE buttons on the phone
set as shown in (Fig.3). Center the SENSOR BOARD MUST as shown. The SENSOR
BOARD MUST be attached to the phone for proper operation.
Align As Shown by Arrows
Fig 3
It should look like this!
This manual is related to the following products:
See also other documents in the category Skutch Electronics Equipment:
- CK-4 (2 pages)
- CK-4 (2 pages)
- BA-22 (2 pages)
- AS-6 (3 pages)
- AS-55 (2 pages)
- AS-26 (2 pages)
- AS-4A (2 pages)
- AS-702 (2 pages)
- AS-702-B (2 pages)
- AS-703-M (2 pages)
- AS-703-SBC (2 pages)
- AS-801 (4 pages)
- AS-801 (6 pages)
- BA-5 (2 pages)
- BA-704-2 (2 pages)
- BA-704 (2 pages)
- CK-1A (5 pages)
- CK-1A3 (4 pages)
- CK-1A4 (4 pages)
- CK-1A4 (4 pages)
- CK-1A6 (4 pages)
- CK-1A6 (4 pages)
- CK-1A7 (4 pages)
- CK-1P3 (4 pages)
- CK-1P4 (4 pages)
- CK-1P5 (4 pages)
- CK-1P5 (4 pages)
- CK-1P6 (4 pages)
- CK-1P6 (4 pages)
- CK-1P7 (5 pages)
- CK-1P (5 pages)
- CK-1P8 (4 pages)
- CK-1P9 (4 pages)
- CK-1R2 (4 pages)
- CK-1R3 (4 pages)
- CK-1R3 (4 pages)
- CK-1R4 (4 pages)
- CK-2 (5 pages)
- CK-7 (2 pages)
- DL-11 V3.00 (2 pages)
- EX-12 (2 pages)
- DL-4 (7 pages)
- BA-1000 V3.12 (16 pages)
- BA-1000 V5.xx (18 pages)