Sierra Video Pro XL Series 8 - Manual (Page 63)

GENERIC PROTOCOL
57
Example:
** G VAR1, MUTE_DELAYS, 5, 100~!! Set the amount of time to mute the signal before turning it on
to the maximum value of 10 seconds.
** G VAR1, MUTE_DELAYS, 6, 35~!! Set the delay time to 3.5 seconds.
SYNC_REPORT: Query for sync rate info for sources connected
to pulse boards
Action From Syntax
Modify Host (none)
Query Host G SYNC_REPORT,,~
Query
Response
Router G SYNC_REPORT,< level num >,< input num >,~
Modify is
Protected:
N/A
Report
Changes:
No
Some routers include ‘pulse’ boards that can report the sync rate of the sources connected to
them. This command is a query only command to obtain a source sync rate.
<frequency> is the value returned in the response message and gives the sync rate frequency in
hertz. This value has a resolution of 21 bits and thus a maximum value of 2.09Mhz.
For example, to query for the sync rate of source 2 on level 5:
**G SYNC_REPORT,5,2~!!
The returned response could be:
**G SYNC_REPORT,5,2,35535~!! - or -
**G SYNC_REPORT,5,2,0~!! Indicating that no signal is connected to that source on level 5.
*Details of the “G” command can be found on our website or by contacting the factory.