Seaward 100 PrimeTest - Manual (Page 9)

PrimeTest 100 Operating Instructions
7
2 Introduction
The PrimeTest 100 is a hand held battery powered
unit suitable for carrying out electrical safety checks
on:
• Class I appliances
• Class II appliances
• IEC mains leads
• Extension leads
• Mains outlet wiring
Numbers shown in circles e.g. refer to fi gure
1 and fi gure 2 on page 6.
Test connections on the PrimeTest 100 are:
•
Mains socket on front panel for connecting
the appliance under test.
• 4mm socket on end panel for earth test probe
• IEC socket on end panel for mains cord
testing.
User Interface
The LCD display shows test progress, results
for individual tests and the overall test result for an
appliance or mains cord.
Tests are initiated using the three push buttons:
Power ON/OFF = + until two beeps are heard
Class I appliance test =
Class II appliance test =
Cord / extension lead test =
Note: The PrimeTest 100 will automatically
switch OFF after approximately 3 minutes if no
keys are pressed. The auto switch-off is disabled
during a power socket test.
1
1
6
7
5
2 3
2
3
4