RJS Inspector D4000 Auto Optic (FIRMWARE version A.06 and Later) - Manual (Page 30)

Inspector D4000
™ Auto Optic
Operator
’s Guide
RJS, Minneapolis, MN 002-5564
7.0 Scanning Symbols
Scanning Techniques

Lay the symbol to be scanned on a flat, non-
reflective surface.

For greatest accuracy scan a symbol more than
once, in both directions.

Begin a scan from the
“quiet zone”
, two inches (5
cm) before the symbol. See Appendix D for details

Make sure the scan head is flat against the symbol.

Move the scan head across the symbol in a smooth
motion. A constant speed of 5 to 10 inches
(13-25 cm) per second is ideal. Scanning too fast
will cause the LCD display to read
“Please Scan
Slower
” but
faster is ALWAYS better than slower.
Scanning Results
After a bar code is scanned, the RJS Inspector D4000
will respond with a crisp, chirp (or beep) sound.
Inspector Display after a scan when set to multiple scan
analysis:
01928374
01 Scans Remain.
Press Select to view the grade for the previous scan:
01928374
C39 Pass ABC-DF
Grade B/06/660
3.0/06/660
Note:
See 8.0 Pass/Fail Analysis Screen section for details the
inspection tests and results