RJS Inspector D4000 Auto Optic (FIRMWARE version A.06 and Later) - Manual (Page 21)

Operator
’s Guide
Inspector D4000
™ Auto Optic
002-5564 RJS, Minneapolis, MN 13
5.2 Scan
After finishing calibration press Select and Enter at the
same time; the
“Ready Menu” will display:
Scan Calib Setup
Storage Inactive
D4000A Ver x.xx
In addition to CALIB, explained in the previous section,
there are 3 additional
“s
electable
” functions:
Scan,
Setup and Storage:

Press Select to choose an option.

Press Enter to initiate processing for that option.
Select Scan (from the Main Menu) to display the initial
Pass/Fail Analysis screen for the previously scanned bar
code.
Note:
A bar code can be scanned at any time except when the
unit is printing