Led display only displays part of the image, Signal needs to scale, No display in the second half part of led display – RGBLink VSP 112W User Manual User Manual

Page 120: Resolution is insufficient, Sending card can not take lower part, Left screen appears two black sides, Adjust de deviation, Led display only shows part of the image

VSP 112W User Manual 120

Signal Needs to Scale

Press [SCALE] button in the processor and knob to adjust the actual

screen size of the screen, combined with button [POSITION], including the

"width", "height" and "starting position", remember to touch the knob to

confirm.

Resolution is Insufficient

Please make sure the points of the screen width and height, choose the

resolution to be bigger than screen width by button [MENU] under

OUTPUT RES, and touch knob to confirm.

Sending Card Can not Take Lower Part

TS 802 can control the max horizontal resolution 2048, and vertical

resolution 640. Each CAT5 output is 320 pixels.

Adjust DE Deviation

This phenomenon needs to adjust the DVI output and DE migration of the

processor, through the [MENU] to find "OUTPUT" and find the

corresponding output name, such as "DVI1 OUT ADJUST", and find "DVI1

DE" again, make an adjustment for corresponding horizontal and vertical

DE, please remember to save to the corresponding channel after setting up,

save to SAVE1 by default.