No output in large screen, Confirm if there are any input singles, Confirm if single output – RGBLink VSP 3600 User Manual User Manual

Page 124: Large screen output flash point, Confirm if preview output is normal, Large screen only display part of the image, Signal need to scale, Common questions and solution

7. Common Questions and Solution

VSP 3600 User Manual 124

Confirm if there are any input singles

Press 【MENU】to find "Device information" , check if the INPUT signal is

normal via 【 NEXT 】, if suggest "NO INPUT", means no signal. Check

the front-end signal line, please note do double show or expand for

computer. Can enter other formats signal to do the same operation.

Confirm if single output

Find a belt VGA input (best for DVI) display, connect to the corresponding

output port of processor, check whether the signal is correct on the

monitor. If not display properly, please check whether there is input signal,

or if input wire interface is taken tight, output wire interface is picked up

tightly. If display normally, check if sending card is normally working or

need to replace sending card test.

Confirm if preview output is normal

Find a belt VGA input (best for DVI) display, connect to the corresponding

output port of processor, check whether the signal is correct on the

monitor. If display normally shows and no flash point, please check

whether DVI outlets put tight or replace to DVI line of sending card. If

display flash point, please judge if input signal, wire, and interface is

normal.

Signal need to scale

Press 【Scale】, rotate the knob to adjust the size of screen size, including

"Width", "Height" etc. Press【NEXT】to confirm.