How to recall the saved parameters, System setup and operations – RGBLink VSP 3600 User Manual User Manual

Page 121

6. System Setup and Operations

How to recall the saved parameters?

VSP 3600 User Manual 121

Firstly, ensure the equipment is on power and run normally. For details,

please refer to:

Button operation is as follows:

1. When VSP 3600 function setting is finished, VSP 3600 provide 10

groups of saving modes in order to avoid setting again when you use

the same function or set again after restarting because of power out.

In CUSTOM ADJUSTMENTS area, press 【 Load 】 key to enter

user recall the saved parameter option.

LOAD FROM 1 corresponding button 1 in SOURCES area;

LOAD FROM 2 corresponding button 2 in SOURCES area;

LOAD FROM 3 corresponding button 3 in SOURCES area;

LOAD FROM 4 corresponding button 4 in SOURCES area;

LOAD FROM 5 corresponding button ALL in SOURCES area;

LOAD FROM 6 corresponding button DVI1 in OUTPUTS area;

LOAD FROM 7 corresponding button DVI2 in OUTPUTS area;

LOAD FROM 8 corresponding button DVI3 in OUTPUTS area;

LOAD FROM 9 corresponding button DVI4 in OUTPUTS area;

LOAD FROM 10 corresponding button Freeze in Layer Functions

area.

2. LCD displays as follows, rotate UP/DOWN knob, and choose recall

and save option;

3. Press menu【NEXT】key to confirm save parameter;

LCD displays the save result:

LOAD
> LOAD FROM 1~10

LOAD FROM 1
LOAD FINISH

Finished!l