How to set picture size in split effects, How to set, Picture size in split effects – RGBLink VSP 3600 User Manual User Manual

Page 114: System setup and operations

6. System Setup and Operations

How to set picture size in split effects?

VSP 3600 User Manual 114

Firstly, ensure the equipment is on power and run normally. For details,

please refer to:

Button operation is as follows:

1. When VSP 3600 is under split mode, in EFFECTS area,【 Split 】 key

lights;

2. In OUTPUTS area, press any key of 1, 2, 3, 4, select pre-regulating

outputs, key lights, and it is selected;

3. In CUSTOM ADJUSTMENTS area, press 【 Scale 】 keys, key lights,

and you can set the size of output image;

4. Light spin around knob and upper and lower knob, set the size of

output image;

5. In OUTPUTS area, press DVI1, DVI2, DVI3, DVI4 again, regulate the

selected output, repeat item 3 and 4 operation to complete regulation

setting.