How to realize the system mode setting, Standard, Single image switching – RGBLink VSP 628PRO Quick Start User Manual

Page 8: Pip setting

Address：S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen,Fujian Province, P.R.C

Tel: 00865925771197 Fax: 00865925771202

Email: [email protected] http://www.rgblink.cn

Push the [MENU] button to enter to the menu items, choose , push the knob to confirm. Turn

the knob, choose , user can choose the mode according to actual need.

1. Standard

In this mode, all the inputs are the same image, the same resolution, and support fade in fade out

switch. Each input signal supports scale, effects setting independently.

Single Image Switching

VSP 628PRO can realize seamless effects switching between two channels. Push the signal button,

and the signal will be switched to the LED display.

For example, the [SDI1] button light is on, it means the signal of LED display is SDI1, if user need to

switch to VGA signal, push the [VGA] button, and the signal will be seamless cut or fade in fade out to

the LED display. User can adjust the switch speed in option in by pushing

the [MENU] button.

PIP Setting

Enable the PIP function:

VSP 628PRO supports seamless switch in single image and double images. Push the [PIP] button, the

button light is on, and enable the PIP function.

Choose the signal in PIP:

VSP 628PRO can output two same or different signals to the LED display, the settings are as follows:

1. Push the [PIP] button, and enable the PIP function.

2. Push the [SCALE] or [DIMMER] button, choose , and push the knob to confirm. (User

can also choose in or option by pushing the [MENU] button.)