RGBLink VSP 628PRO Quick Start - Manual (Page 13)

Address：S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen,Fujian Province, P.R.C
Tel: 00865925771197 Fax: 00865925771202
Email: [email protected] http://www.rgblink.cn
12
How to Do Customized Output Resolution
Push [MENU] button to enter to the menu items, turn the knob and choose ustom Formats>, push
the knob and confirm.
1. Turn the knob on each digital position, and change the value of the digital by the digital buttons on the
front panel.
2. After the digital, push the knob will add ×, means before × is the horizontal size. Same operation for
vertical size.
3. After the digital, push the knob will add ×, means before the × is the vertical size, and after the × is
the refresh rate. Only digital 50 or digital 60 supports for the refresh rate. Use the digital buttons to
finish the settings.
4. After input all the values, push the knob to enable VSP 628PRO to output this resolution.
VSP 628PRO will take 5~10 seconds to enable this output resolution.
How to Realize the Test Pattern Setting
Push the [LOGO] button, user can set the test pattern, the settings are as follows:
Type: Choose the test pattern type, including LOGO, H RAMP, V RAMP, 100% COL BAR, 75% COL
BAR, 16*16 GRID, 32*32 GRID, BURST, 50% GRAY, GRAY STEP1, GRAY STEP2, WHITE、BLACK
and SMPTE COL BAR.
Raster Box: User can choose enable or disable the raster box function.
Diag Motion: User can choose enable or disable the diag motion function.
AOI Raster Box: User can choose enable or disable the AOI raster box function. If choose “ON”, user
can choose the types including Box X, Box Y, Box Width and Box Height. If image quality distorts by
improper operation, it can be recover by reset.