RGBLink VSP 628PRO Quick Start - Manual (Page 10)

Address：S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen,Fujian Province, P.R.C
Tel: 00865925771197 Fax: 00865925771202
Email: [email protected] http://www.rgblink.cn
9
out switch. Each input signal supports scale, effects setting independently.
Same operation with stand mode, in this mode, user can switch the signal, set the size and position,
mask the image and adjust the dimmer and effects. User need to choose the channel in
Select> before setting.
For example, choose the signal of CHB, first, push the [MENU] button to enter to menu items, choose
, push the knob to confirm, turn the knob, choose , turn the knob to choose
CHB. Then choose the signal, CHB will switch to the selected signal.
3. Switcher
In this mode, the HDMI output is preview image, and the DVI and VGA output is program image,
preview signal can not support fade in fade out switch, and program signal supports.
Same operation with stand mode, in this mode, user can switch the signal, set the size and position,
and mask the image. All the settings above are for preview, push [TAKE] button after setting, and the
preview image will be cut or fade in fade out to the program.
4. Split
In this mode, user can set split simply, and can set the split parameters of single or multiple devices
quickly. The split operations are as follows:
Project: There is one LED display, the size is 3684x1152, divide into right and left halves, the left width
is 1824 and the right width is 1860, we will cascade the two LED displays with one VSP 628PRO, and
display a complete picture in the whole screen.
(1) Connect the interface
Connect the DVI signal to the DVI input interface, connect the DVI output to the left LED sending card,
and connect the HDMI output to the right LED sending card.
(2) Choose the system mode
Push the [MENU] button to enter to the menu items, turn the knob to choose :