How to cascade the device – RGBLink New Driver Quick Start User Manual
Page 9

Address:S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen,Fujian Province, P.R.C
Tel: 00865925771197 Fax:00865925771202
Email: [email protected] http://www.rgblink.cn
8
1. Push MENU button of Device 2, rotate the knob, choose [CASCADE], and choose ON.
2. Connect the computer and Device 1 with USB cable, then connect the male port of DB9 serial line to
the female port of Device 1, and connect the female port of DB9 serial line to the male port of Device 2.
3. Set cascade dial switch 1 downwards, and set cascade dial switch 2 upwards, then Device 1 and
Device 2 cascade is finished.
4. Push MENU button of Device 3, rotate the knob, choose [CASCADE], and choose ON.
5. Connect the male port of DB9 serial line to the female port of Device 2, and connect the female port of
DB9 serial line to the male port of Device 3.
6. Set cascade dial switch 1 upwards, and set cascade dial switch 2 downwards, then Device 2 and
Device 3 cascade is finished.
7. Push MENU button of Device 4, rotate the knob, choose [CASCADE], and choose ON.
8. Connect the male port of DB9 serial line to the female port of Device 3, and connect the female port of
DB9 serial line to the male port of Device 4.
9. Set cascade dial switch 1 and cascade dial switch 2 downwards, then Device 3 and Device 4 cascade
is finished.
Currently, it can cascade 4 sets of device, it is only available for Linsn sending card currently.
Note
DB9 serial male port DB9 serial female port
Note
Cascade is only for upper computer control of
sending card.