RGBLink New Driver Quick Start - Manual (Page 18)

Address：S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen,Fujian Province, P.R.C
Tel: 00865925771197 Fax:00865925771202
Email: [email protected] http://www.rgblink.cn
17
Linsn Sending Card Panel Installation
1. Lock Linsn sending card by 6 screws P (3*5), as shown in the below red circle, and by two screws
(3*6) with a flat pad screws power ground, as shown in the blue box shown in the diagram below. Then
take a terminal line ( φ 4.0 round head terminal, +5 mm immersion, 1015-18 #/, yellow green double
color line, 170 mm long), weld one end of the subline to the stand on network interface of sending card:
Note: Lock the sending card with welding line to the left position in the above figure.
2. Set the dial switch of sending card, as shown in the following figure.