RGBLink New Driver Quick Start - Manual (Page 10)

Address：S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen,Fujian Province, P.R.C
Tel: 00865925771197 Fax:00865925771202
Email: [email protected] http://www.rgblink.cn
9
How to Realize LED Screen Connection
New Driver can realize two connection as follows connecting the Port D or Port U of one sending card
to LED screen, connecting the both Port D and Port U of one sending card to LED screen. The following
are the detailed operation steps of the three connection.
1. Connect the Port D or Port U of One Sending Card to LED Screen
(1) First, make sure that the device is in normal operation. The red power indicator lights
when the device has power supply and the green signal indicator lights when device
has signal input.
(2) Choose the input source, for example, DVI.
(3) Connect the cable to Port U.
(4) Turn the knob, choose [SENDING CARD TYPE], push the knob to confirm, turn the
knob, choose the sending card model, for example, Linsn (New Driver can only
support Linsn and Colorlight sending card). Shown as follows:
(5) After setting, turn the knob, choose [QUICK POINT SCREEN], push the knob to
confirm for next setting, shown as follows:
*SENDING CARD TYPE LINSN
BRIGHTNESS >>
QUICK CONNECTION >>
EDID >>
>SENDING CARD TYPE NOVA STAR
BRIGHTNESS >>
QUICK CONNECTION >>
EDID >>