beautypg.com

RGBLink New Driver Quick Start User Manual

Page 17

background image

Address:S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen,Fujian Province, P.R.C

Tel: 00865925771197 Fax:00865925771202

Email: [email protected] http://www.rgblink.cn

16

Sending Card Panel Installation

Please process the sending card panel before install the sending card. Operations are as follows:

1. Take a piece of sending card, and remove the stand of the LEDs, weld on a 2*2 pin, 2.54 mm pitch

row needle, as shown below (applicable to LINSN, Colorlight T7 and Nova sending card).

2. Take another sending card and a 3P double line (30 cm long, 2.54 pitch), cut one side of the stand,

and weld to the back of sending card, as shown in the figure below:

Note: Step 2 is only applicable for Linsn sending card.

3. After welding, connect the other end of 3P double line to the red box area of MCU board, as shown in

the figure below: