REMKO BL 261 - Manual (Page 9)

▲/▼
Keys
The ▼ key can be used to reduce the desired target temperature, the
▲ key can be used to increase it. In automatic mode, the temperature
can be increased or decreased by 1°C. In dehumidification mode, no
temperature adjustment can be made.
Cooling mode
The display turns off
after 1 min.
Automatic mode
MODE key
Use the MODE key to switch between individual operating modes. A to-
tal of 4 modes are available:
1. Automatic cooling or heating operation
2. Cooling primarily summer mode
3. Dehumidifying operating mode for summer or winter
4. Heating
mainly a winter operating mode
MODE MODE MODE
Automatic Cooling Dehumidification Heating
In automatic mode, the controller autonomously selects between heating
and cooling operation when the unit is first switched on. The control
range lies between 22°C and 26°C. This can be increased or decreased
with the
▲/▼ keys.
AUTOMATIC MODE
AUTOMATIC
MODE
In cooling mode, the air in the room is cooled to the set target
temperature. The desired room temperature is set with the
▲/▼ keys
in 1°C increments. If the room temperature is 0.5°C above the selected
target temperature, then the interior unit starts to cool the air in the
room. If the temperature falls to approx. 1°C below the set room
temperature, the controller will switch off cooling mode. To protect the
compressor, the controller only turns cooling on again after a wait time of
3 minutes.
COOLING mODE
COOLING
MODE
MODE
▼ ▲
▼ ▲
9