REMKO BL 261 - Manual (Page 8)

The remote control standby mode is signalled by the blinking dot on the
remote control. Stand by of remote control
RESET key The remote control can be reset by pressing the RESET key in the battery
compartment. The time can then be programmed (see "CLOCK key").
RESET 5 sec. Setting the clock
The time can be programmed by pressing the CLOCK key inside the
battery compartment. "CLOCK" blinks in the display and the current
time is set via the HR. and MIN. key. Programming is completed by
pressing the CLOCK key again. The display will stop blinking.
CLOCK Key
CLOCK HR/MIN CLOCK
Your air conditioner is activated and deactivated by pressing the ON /
OFF key. The programmed settings and adjustment values from before
the unit was turned off will appear on the display.
ON/OFF key
ON/OFF ON/OFF
A symbol is shown on the display to indicate that the settings are being transferred.
Key functions
REMKO BL
8