REMKO BL 261 - Manual (Page 6)

Display on indoor unit
The display illuminates according to the settings.
max. 6 m
max. distance 6 m
Display on indoor unit
Timer Automatic mode
Fan speed
Display
of coded error
messages, room and
target temperature
Cooling mode
Swing mode
Sleep function
Dehumidification mode Temperature unit
Heating mode
Operation
Infrared remote control
The infrared remote control
sends the programmed settings
a distance of up to 6 m to the
receiver of the indoor unit.
Data will only be received correctly
if the remote control is pointed
at the receiver and no objects are
obstructing the transmission path.
First insert the supplied batteries
(2 each, type AAA) into the remote
control. To do so, remove the flap
from the battery compartment and
insert the batteries the correct way
around (see markings).
The indoor unit is easy to operate using an infrared remote control. This is supplied as standard. The indoor unit
beeps to acknowledge the correct transmission of data. If it is not possible to program the indoor unit using the
remote control, it can also be operated manually.
Problems are shown in code
(see Troubleshooting and
Customer service section).
! ATTENTION
Immediately replace flat
batteries with a new set,
otherwise there is a risk of
leakage.
It is recommended that the
batteries are removed if the
equipment is shut down for
long periods.
NOTE
Manual mode
The indoor units can be
commissioned
manually. After the air inlet screen
has been opened, the inner
recessed key can be pressed and
automatic mode can be activated.
In manual operation, the following
settings apply:
Cooling mode: last setting
Fan speed: AUTO
Heating mode: last setting
Fan: AUTO
Press a key on the infra-red
remote control to interrupt manual
operation.
Help save on energy consump-
tion in stand-by mode! If the
device, system or component
is not in use, we recommend
disconnecting the power sup-
ply. Components with a safety
function is excluded from our
recommendation!
TIP
REMKO BL
6