QVidium QVMP2C-1011 - Manual (Page 9)

User’s Manual v.28 QVidium™ MPEG2+4 Codec
Figure 1: Encoder profile form.
2.3 Stopping and Reconfiguring the Encoder
Enter http://IPAddress where IPAddress is the IP address of the encoder.
1. If
the Encoder menu is not shown, select Encoder on the left side of the web page.
2. Select
the Stop menu option underneath the Encoder menu. You should see the following
message at the top of the web page main area.
Encoder is Stopped.
3. To reconfigure the encoder, go back to the steps in Sections 2.1 and 2.2.
NOTE: Changing from encode to decode requires power cycling the system.
9 of 45 - Copyright 2007-2008 QVidium™ Technologies, Inc.