QVidium QVMP2C-1011 - Manual (Page 22)

User’s Manual v.28 QVidium™ MPEG2+4 Codec
22 of 45 - Copyright 2007-2008 QVidium™ Technologies, Inc.
7.2 Re-Initializing Flash Memory
Depressing the reset button during reboot (within the first few seconds after applying power or
rebooting the system) will erase and restore the application partition of flash memory from a factory
default copy stored in the lower-level of read-only flash memory.
• Cleaning Flash and Restoring Application Memory – Retains User Settings
Holding in the reset button for more than 15 seconds (but less than 30 seconds) during reboot
will erase all of the contents of the application partition of flash memory and restore it with the
default version of the codec applications and web pages from default image stored in the lower-
level, read-only partition of flash memory. However, this reset mode will first save all user settings,
such as IP address and password, and then restores these settings after it restores the application
software.
• Initializing Flash and Restoring Application Memory – Factory Settings
Holding in the reset button for more than 30 seconds during reboot will first re-initialize and
reformat flash memory before restoring the default application software. It will also erase any user
settings and completely restore the entire system to factory default settings. (However, it will
attempt to save and restore any license files.)
NOTE: USE THIS RESET MODE AS A LAST RESORT, such as if the system becomes
completely unresponsive.