Decoder configuration and operation, 1 decoding profile and web interface – QVidium QVMP2C-1011 User Manual
Page 13
User’s Manual v.28
QVidium™ MPEG2+4 Codec
3
Decoder Configuration and Operation
As with the encoder, the decoder can be configured and operated from a web browser. This section
describes how to configure and operate the decoder.
3.1 Decoding Profile and Web Interface
You must use the web interface to edit the decoding profile.
Enter http://IPAddress where IPAddress is the IP address of the decoder. For example,
http://192.168.1.100.
1. Make certain that the encoder is stopped as explained in Section 2.3.
2. Select
the
Decoder
menu on the left side of the web page.
3. Select
the
Profile
menu option underneath the Decoder menu.
A Decoder Profile interface should display in the main area to the right of the menu
system as shown in Figure 2a through 2c, below and in Appendix B.
Figure 2a: Decoder profile form: “Decoding Tab”
13 of 45 - Copyright 2007-2008 QVidium™ Technologies, Inc.