QVidium QVMP2C-1011 - Manual (Page 40)

User’s Manual v.28 QVidium™ MPEG2+4 Codec
Notification
The parameters below ONLY pertain to QVidium sender-notification feature. This feature
allows the decoder to receive a unicast stream in applications where the decoder’s IP
address is not initially known or may change and when security concerns may not permit
multicast operation. In this mode of operation, the decoder transmits its IP address to a
specified encoder each time the decoder is started. The encoder then dynamically changes
its destination address to the address that it receives from the decoder each time the
decoder sends this notification to a different destination address to the encoder.
Notify Encoder: Select No to disable this feature. Select Yes to enable it.
Encoder IP Address: Enter the IP address of the encoder to which the decoder will send
the notification messages.
Encoder Password: The QVidium MPEG2+4 Codec implements password protection on
all access to its configuration settings. In order for the decoder to change the encoder’s IP
destination address, you must specify the password for the encoder in this field.
40 of 45 - Copyright 2007-2008 QVidium™ Technologies, Inc.