Introduction, 1 overview, 2 network setup – QVidium QVMP2C-1011 User Manual
Page 3
User’s Manual v.28
QVidium™ MPEG2+4 Codec
1
Introduction
Introduction
Congratulations on purchasing the QVidium™ MPEG2+4 Codec.
Congratulations on purchasing the QVidium™ MPEG2+4 Codec.
QVidium™ MPEG2+4 Codec
1.1 Overview
The MPEG2+4 Codec can be configured to encode or decode video using either MPEG-2 (main
profile) or MPEG-4 (simple profile) compression and to interface with resulting video stream over
standard Ethernet/IP networks. With the QoS option, the MPEG2+4 Codec includes the latest
industry-standard Pro-MPEG Forum Forward Error Correction (Code of Practice 3, release 2), and
also implements QVidium’s patent-pending advanced ARQ Error Correction and Packet Pacing.
With these advanced Quality of Service (QoS) features, the MPEG2+4 can send video over nearly
any network and across the world, including wireless connections and the public Internet, with
unsurpassed video transport quality.
1.2 Network Setup
The MPEG2+4 Codec comes with a factory preset IP address of 192.168.1.100 and Netmask of
255.255.255.0. You can download and run our CodecManager application to change the IP
settings, even when the IP address has been reset to an unknown address. Please refer to section
8 of this manual for configuration using the CodecManager application.
The MPEG2+4 Codec can also be reconfigured through a web browser when you know the IP
address. Follow the steps below to reconfigure the network settings through a web browser on a
computer connected to the same subnet as the Codec.
1) Point your web browser to
NOTE: The MPEG2+4 Codec requires user authentication to enter the web browser or to log in
using Telnet. The factory preset username is “root” and the password is also “root.” Please enter
these settings when prompted to access the system.
2) Click on “Configure” under the “Network” menu on the left.
3 of 45 - Copyright 2007-2008 QVidium™ Technologies, Inc.