QVidium QVMP2C-1011 - Manual (Page 39)

User’s Manual v.28 QVidium™ MPEG2+4 Codec
UDP port. However, you must make certain that you specify the same port number at both
the encoder and the decoder.
Server
The parameters below ONLY pertain to the operation of the QVidium MPEG2+4 IP
Codec with a QVidium QoS Proxy Server. Leave this disabled when not connecting to a
QoS Proxy Server.
This feature allows the decoder to initiate and receive a unicast stream from a QoS Proxy
Server. You must provide the IP address and control port for the QoS Proxy Server. The
decoder then sends a control packet upstream to the server when you start the decoder.
Use Server: Select No to disable this feature. Select Yes to enable operation with a QoS
Proxy Server.
IP Address or Hostname: Enter the IP address of the QoS Proxy Server to which the
decoder will send a start-stream message.
Echo Port: Normally, this should be left to the default UDP port 7. This port number must
match the value at the QoS Proxy Server. In addition, you may need to configure a firewall
at the server to allow ingress for packets on this port.
39 of 45 - Copyright 2007-2008 QVidium™ Technologies, Inc.