QVidium QVMP2C-1011 - Manual (Page 6)

User’s Manual v.28 QVidium™ MPEG2+4 Codec
6 of 45 - Copyright 2007-2008 QVidium™ Technologies, Inc.
1.4 Passwords and Security
The QVidium MPEG2+4 Codec requires a username and password to protect access to its
configuration settings. This includes both Web access and Telnet access. The default user name is
“root” and the default password is also initially set to “root.” You can change the password by
selecting the Password menu item under the System Menu at the upper left of the Web page.
1.5 Resetting to Default Settings
If you later forget the password or IP address, you can reset the these settings back to their initial
factory defaults by pressing and holding the reset button in the small hole found on the side of the
Codec for more than 2 seconds. As mentioned above, this reset will reset the networking settings
to the default IP address of 192.168.1.100 and the password back to “root.”
1.6 Upgrading
QVidium provides firmware upgrades from time to time to add new features, overcome limitations,
or to fix bugs. QVidium would provide any upgrades as a .pkg file that you can upload into the
Codec via the web browser interface. To perform an upgrade, just follow the following steps:
1) Copy the upgrade .pkg file into a convenient location on your PC.
2) Point your web browser to the Codec and click on “Upgrade” in the “System” menu.
3) Click on the “Browse” button and locate the upgrade file.
4) Click on “Upgrade” and wait for the upgrade to finish. DO NOT DISCONNECT FROM
POWER OR INTERRUPT THIS OPERATION UNTIL IT COMPLETES.
5) Click on “Reboot” from the system menu to reboot the Codec.